Mk-diamond MK-100 JCS Manual de usuario descargar pdf (Pagina 22)

MK-100 JCS Tile Saw Revision 06/05, Effective Date June 27, 2005

SETUP, ADJUSTMENT and OPERATION

2. Diagonal Cutting:

NOTE: To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134557-MK) should be used.

DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.

NOTE: If Cutting the tile in two equal halves, align the tile in the V-notch of the Movable Cutting Table

Ruler/Stop.

(A)

Remove the Adjustable Cutting

Guide

Turn counter-

clockwise to loosen

Ruler/Stop

Adjustable

Cutting Guide

(E)

Turn the motor ON

(F)

Verify proper cooling flow on

both sides of the blade (See

Maintenance Section to

increase/decrease flow)

Off

Position

ON/OFF

Switch

(H)

Turn the motor OFF when

work is complete

(B)

Place the Dual 45º Flat Angle

Guide on the Ruler/Stop

(C)

Position the Dual 45º Flat Angle

Guide and tighten the

retaining thumbscrew

(D)

Position the tile against the Dual

45º Flat Angle Guide and the

Ruler/Stop

(G)

Perform the cut

Ruler/Stop

Turn counter-

clockwise to loosen

Align Guide

to Ruler/Sto

Turn Clockwise

to tighten

45º Flat

Angle Guide

Ruler/Stop

Position

ON/OFF

Switch

Cooling Flow

Points

Hold Work

in Position

Direction

of Cut

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 48 49

Comentarios a estos manuales

Sin comentarios

Mk-diamond MK-100 JCS Manual de usuario Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Motosierras Mk-diamond MK-100 JCS